13
How to use the Remote Control
How to use the Remote Control
The Remote Control is capable of performing basic
Operating Functions for the MR87 AM/FM Tuner.
Note: Refer to the “How to Operate” Section of this
manual for additional information using this
Remote Control, starting on page 20.
Manual Tuning
Use the BAND Push-button to select AM or FM.
Press the DIRECTIONAL Upp or Downq Push-
button to move from station to station (AM or FM).
Automatic Tuning
Use the BAND Push-button to select AM or FM.
Press the SEEK 7 down or 8 up the dial Push-button
to move to the next station (AM or FM).
Preset Tuning
Use the BAND Push-button to select AM or FM.
Press the PRESET 9 down or : up the dial Push-
button and the MR87 will stop on the next Station in
Preset Memory.
Note: For information on entering a Station into
memory, refer to pages 20 thru 22.
Direct Preset Access
To access the desired Station previously assigned to a
Preset stored in memory, perform the following:
1. Press the BAND Push-button to select AM or FM
desired Preset.
2. Press the PRESET Push-button.
3. Using the 0 through 9 numeric Push-buttons enter
the Preset Number.
Note: When selecting a Preset 1 through 9 and
there are more than ten Presets entered into
memory for the given Band (AM or FM) there
is a two second delay before the MR87 will go
to the single digit Preset.
Direct Station Access
To access a desired Station perform the following:
1. Press the BAND Push-button to select AM or FM
desired Preset.
2. Using the 0 through 9 numeric Push-buttons enter
the Frequency Number of the Station (for AM or
FM).
Note: When entering a FM Station, there is no need
to enter the decimal point.
Kommentare zu diesen Handbüchern